Additions:
For the purists I will start with the disclaimer, this is not the recommended way from the FSM
**1.** the o-ring makes the seal at the bottom in a bore similar to the way all the other tube seals are done on the top of the turbo drain and the air cleaner drain
**2.** using the FSM method you have to force the tube all the way through the big seal from the top, which is nearly impossible. it also peels off the oring while its trying to go in
**Heres the easy way:**
**1.** Put the big seal on the lower tube, you can push it through the bottom pretty easy, i put oil on it to help but it was not too hard.
**2.** Put the orings on the lower tube.
**3.** Push the lower tube into the upper pan hole, you will feel it "snap" in and hit bottom.
**4.** Put on the top tube by bending the lower tube slightly to the side
**5.** Snap the lower seal into the upper pan hole.
**6.** Snug the 2 upper tube bolts after putting in the gasket
**7.** Pull the lower tube up as far as it will go in the upper tube.
**8.** Tighten the 2 nuts.
Viola. I did this with one hand in less than 2 minutes. I took it apart and redid it 3 times to make the video linked below. works like a charm.....
**1.** the o-ring makes the seal at the bottom in a bore similar to the way all the other tube seals are done on the top of the turbo drain and the air cleaner drain
**2.** using the FSM method you have to force the tube all the way through the big seal from the top, which is nearly impossible. it also peels off the oring while its trying to go in
**Heres the easy way:**
**1.** Put the big seal on the lower tube, you can push it through the bottom pretty easy, i put oil on it to help but it was not too hard.
**2.** Put the orings on the lower tube.
**3.** Push the lower tube into the upper pan hole, you will feel it "snap" in and hit bottom.
**4.** Put on the top tube by bending the lower tube slightly to the side
**5.** Snap the lower seal into the upper pan hole.
**6.** Snug the 2 upper tube bolts after putting in the gasket
**7.** Pull the lower tube up as far as it will go in the upper tube.
**8.** Tighten the 2 nuts.
Viola. I did this with one hand in less than 2 minutes. I took it apart and redid it 3 times to make the video linked below. works like a charm.....
Deletions:
1. the oring makes the seal at the bottom in a bore similar to the way all the other tube seals are done on the top of the turbo drain and the air cleaner drain
2. using the FSM method you have to force the tube all the way through the big seal from the top, which is nearly impossible. it also peels off the oring while its trying to go in
Heres the easy way.
1. put the big seal on the lower tube, you can push it through the bottom pretty easy, i put oil on it to help but it was not too hard.
2. put the orings on the lower tube.
3, push the lower tube into the upper pan hole, you will feel it "snap" in and hit bottom.
4. put on the top tube by bending the lower tube slightly to the side
5, snap the lower seal into the upper pan hole.
6. snug the 2 upper tube bolts after putting in the gasket
7. pull the lower tube up as far as it will go in the upper tube.
8. tighten the 2 nuts.
viola. I did this with one hand in less than 2 minutes. I took it apart and redid it 3 times to make the video linked below. works like a charm.....
